Cut-Off Delay - Pc Board D210 - Siemens SIREMOBIL Iso-C Troubleshooting Manual

122

Cut-off delay - PC board D210

Fig. 37:
WARNING
NOTE
In the monitor trolley, PC board D210 is installed above the line power filter
((Fig. 37 / p.
Disconnect the system from the power supply by pulling the line power plug plug out of
the socket.
Loosen the 4 fastening nuts of PC board D210.
Unplug all connectors.
Replace board D210 and fasten the new PC board with the 4 nuts.
Reconnect all connectors.
Connect the monitor trolley to the power supply again.
Switch the monitor trolley on and wait for it to boot.
Check the cut-off delay.
After the power off button has been pressed, the monitor trolley must switch off after
approx. 3 minutes.
SIREMOBIL Iso-C
Replacing boards and components
Electrical voltage!
See (Safety information / p.
Switch the system power supply off and disconnect the
power plug.
Only applies to SIREMOBIL Iso-C 3D.
122)) .
SPR2-230.840.01.01.02
08.08
11).
Page 122 of 148
CS PS SP
6.22
© Siemens, 2008
For internal use only