Appendix A - Innovation Menu Item Descriptions - Watts Aerco Innovation 800 User Manual

Innovation Hot Water Hot Water Boiler User Manual
APPENDIX A – INNOVATION MENU ITEM DESCRIPTIONS
APPENDIX A – INNOVATION MENU ITEM DESCRIPTIONS
Table A-1: Operating Menu Item Descriptions
Table A-1: OPERATING MENU ITEM DESCRIPTIONS
See section 3-4 for a range of choices and the default values.
MENU LEVEL & OPTION
1 Active Setpoint
2 Inlet Temp
3 Air Temp
4 Outdoor Temp
5 Valve Position In
6 Exhaust Temp
7 Valve Position Out
8 FFWD Temp
9 Flame Strength
10 Oxygen Level
11 Ignition Time
12 SSOV Time to OPN
13 Run Cycles
14 Run Hours
15 Fault Log
OMM-0120_0A
GF-128-I
This is the setpoint temperature to which the control is set
when operating in the Constant Setpoint or Remote Setpoint
mode. When in the Constant Setpoint mode, this value is
equal to the Internal Setpoint setting in the Configuration Menu.
When in the Remote Setpoint mode, this value is the setpoint
equivalent to the remote analog signal supplied to the unit
Displays Inlet Water Temperature
For monitoring purposes only
Displayed only if outdoor sensor is installed and enabled.
Desired input valve position. This is normally the same as the
valve position shown on the bargraph when the heater is
operating.
Displays Exhaust Gas Temperature
Displays actual real time Valve Position
Displays Feed Forward Water Temperature
Displays flame strength from 0% to 100%.
Displays the Oxygen Level of combustion exhaust gasses
Displays the elapsed time between confirmation of gas valve
opening (POC) until a stable flame is detected
Displays the elapsed time between 120 VAC being applied to
the Gas Valve and confirmation of gas valve opening (POC)
Displays the total number of run cycles from 0 to 999,999.
Displays total run time of unit in hours from 0 to 9,999,999.
Displays information on the last 20 faults (0 – 19).
AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913
Phone: 800-526-0288
- INTERNATIONAL
DESCRIPTION
Page 127 of 174
11/15/2016