Chapter 2. Installation; Introduction; Receiving The Unit; Unpacking - Watts Aerco Innovation 800 User Manual

Innovation Hot Water Hot Water Boiler User Manual

2.1 INTRODUCTION

This Chapter provides the descriptions and procedures necessary to unpack, inspect and install
AERCO Innovation Hot Water Boiler models INN800, INN1060 and INN1350.

2.2 RECEIVING THE UNIT

Each Innovation Water Heating System is shipped as a single crated unit. The shipping weight
is approximately 1200 pounds (544 kg). The unit must be moved with the proper rigging
equipment for safety and to avoid equipment damage. The unit should be completely inspected
for evidence of shipping damage and shipment completeness at the time of receipt from the
carrier and before the bill of lading is signed.
AERCO is not responsible for lost or damaged freight. Each unit has a Tip-
N-Tell indicator on the outside of the crate. This indicates if the unit has
been turned on its side during shipment. If the Tip-N-Tell indicator is
tripped, do not sign for the shipment. Note the information on the carrier's
paperwork and request a freight claim and inspection by a claims adjuster
before proceeding. Any other visual damage to the packaging materials
should also be made clear to the delivering carrier.

2.3 UNPACKING

Carefully unpack the unit taking care not to damage the unit enclosure when cutting away
packaging materials
After unpacking, closely inspect the unit to make sure there is no evidence of damage not
indicated by the Tip-N-Tell indicator. Notify the freight carrier immediately if any damage is
detected.
The following accessories come standard with each unit and are either packed separately within
the unit's shipping container or are factory installed on the unit:
•
ASME Pressure and Temperature Relief Valve
•
Condensate Drain Trap
If the Innovation Hot Water Boiler is equipped for use with the AERCO Water Heater
Management (WHM) system, an actuator-controlled ball valve will also be included with the unit.
When optional accessories are ordered, they may be packed within the unit's shipping
container, factory installed on the unit, or packed and shipped in a separate container. Any
standard or optional accessories shipped loose should be identified and stored in a safe place
until ready for installation or use.
OMM-0120_0A
GF-128-I
CHAPTER 2 – INSTALLATION

CHAPTER 2. INSTALLATION

NOTE
AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913
Phone: 800-526-0288
- INTERNATIONAL
Page 15 of 174
11/15/2016