Chapter 2
Firmware version confirmation
In order for the equipment to operate properly, the host machine's firmware
version must be the same or later than the version given below.
System: Ver.75.xx or later
Before installing the equipment, confirm the host machine's firmware
version and, if the version is old, use the service support tool to upgrade it.
2.17.2 Checking the Contents
iR C3380i / iR C3380 / iR C2880i / iR C2880 / iR C3580 / iR C3580i / iR
C3080 / iR C3080i / iR C2380i
<Wireless Network Interface Adapter NB-W1>
[1]
1
[3]
[6]
3
F-2-174
[1]
Wireless LAN board
[2]
MFP antenna
[3]*1
Cord guide
[4]
PCB support plate (CL)
[5]*2
Gasket
[6]*3
Antenna affixing tape
[7]
Wireless LAN display label
*1; For this machine, use 1 pieces.
*2; Not used with this model.
*3; Keep the remaining tape from the 3 sheets in a safe place for later use.
< CD/Guides >
- Wireless Network Interface Adapter NB-W1 Users Guide
- Wireless Network Interface Adapter NB-W1 Manual CD
2-42
[2]
2
[4]
[5]
[7]
1 pc
1 pc
6 pc
1 pc
3 pc
1 sheet
1 pc
2.17.3 Turning Off the Host Machine
iR C3380i / iR C3380 / iR C2880i / iR C2880 / iR C3580 / iR C3580i / iR
C3080 / iR C3080i / iR C2380i
See the host machine installation 'Points to Note When Turning Off the Main
Power'.
2.17.4 Installation Procedure
iR C3380i / iR C3380 / iR C2880i / iR C2880 / iR C3580 / iR C3580i / iR
C3080 / iR C3080i / iR C2380i
1. Installation Procedure
1) Release five wire saddles [1] on the rear upper cover, make two cables [2]
coming off upward.
[2]
0018-6104
2) Detach the rear upper cover [1].
- 4 screws [2] (to remove)
- 3 screws [3] (to loosen)
[2]
[1]
3) Remove the cables from the wire saddles [1] and take off the controller
box cover [2].
- 14 screws [3]
Do not make the screws fall off.
[1]
F-2-175
[2]
[3]
F-2-176
0018-6381
0018-6117