Table of Contents
Advertisement
Chapter 2
Points to Note When Routing the Harness
Check to see that the harness [1] is in contact with the reader base plate.
If not, hold the harness [1] down with your hand to keep it in contact with
the reader base plate.
9) Pull the drive belt (front side) [1] to the right to move the contact sensor
unit [2] to the center.
F-2-92
10) Peel off the protective sheet [1], and fit the 2 clamps [2].
(Keep the protective sheet peeled until step 12).)
11) Fix the heater [4] in place using a screw (Binding; M4X6) [3].
12) Fit the connector [5] of the heater in place, and fit the harness of the heat-
er to the clamp [2].
F-2-93
13) Put back the protective sheet.
14) Attach the following units in the reverse procedure of detachment.
- ADF reading glass
- copyboard glass
- glass retainer (left, right)
15) Connect the power cable.
2-24
2.12 Installing the Cassette Heater
2.12.1 Points to Note at Installation
iR C3380i / iR C3380 / iR C2880i / iR C2880 / iR C3580 / iR C3580i / iR
C3080 / iR C3080i / iR C2380i
- In the case of mounting the cassette heater unit to the cassette of the host
machine, the heater PCB needs to be mounted.
- In the case of mounting the cassette heater unit to the cassette pedestal,
the heater PCB and the cassette heater attachment need to be mounted.
2.12.2 Checking the Parts
iR C3380i / iR C3380 / iR C2880i / iR C2880 / iR C3580 / iR C3580i / iR
C3080 / iR C3080i / iR C2380i
Prepare the following parts because each part of the Cassette Heater Unit is
assigned as service part.
[1]
F-2-94
No.
Name
[1]
Heater Unit
[2]
Plastic film
[3]
Screw (binding; M4X6)
2.12.3 Checking the Parts
iR C3380i / iR C3380 / iR C2880i / iR C2880 / iR C3580 / iR C3580i / iR
C3080 / iR C3080i / iR C2380i
Prepare the following parts because each part of the Heater PCB is assigned
as service part.
[1]
F-2-95
[2]
[3]
T-2-4
Part No.
Qty.
FK2-0376-000
1 pc
FC5-6899-000
1 pc
XB1-2400-607
1 pc
[2]
0014-2976
0014-2690
0014-2775
Advertisement
Chapters
Table of Contents
