Ftp Server - FLIR Ariel Gen IIICB-3308 User And Installation Manual

To configure the Wire Setting
1. In the Wire Setting section, from the Speed & Duplex drop-down list, select one of the following:
·
10 Mbps Half Duplex
·
10 Mbps Full Duplex
·
100 Mbps Half Duplex
·
100 Mbps Full Duplex
·
Auto (default setting)
To enable UPnP settings
1. In the UPnP section, from the Enable UPnP drop-down list, select ON. The default is ON. This
enables the camera to be detected by any unit on the LAN.
2. From the Mode drop-down list, select one of the following:
·
IP and Device Name – The camera connects to the UPnP server by using its
IP address and default device name. This is the default setting.
·
Device Name – The camera connects to the UPnP server by using the default
camera name.
·
User Input – The camera connects to the UPnP server by using a friendly
name. Enter the name in the Friendly Name text box that opens when this
option is selected:
To enable SSL
1. In the SSL section, from the Enable SSL drop-down list, select ON. The default is OFF.
Note:
You must install or generate an SSL certificate before enabling SSL.

5.3.1.4.2 FTP Server

The camera includes a built-in FTP server which enables remote access to files of events that are captured
in snapshots or recorded on clips and are stored on the camera's microSD card. The FTP Server screen
is used to enable remote access of the camera's microSD card. No configuration of the camera's internal
FTP server is required by the user. The camera's IP address is ftp://<camera IP address>.
March 10, 2019
UPnP User Input Screen
CB-3304/CB-3308 User and Installation Guide
Configuration and Operation
45