Network - FLIR Ariel Gen IIICB-3308 User And Installation Manual

Note:
If the camera is attached to Latitude, motion detection configuration should be done from Latitude
Admin Center, not from the web interface.
To enable motion settings
1. Click Enable. By default, Enable is not checked.
2. Click Save Area.
Note: The camera can only support either motion detection or analytics at a single time, but not both
at the same time.
To configure motion zone area settings
1. From the Sensitivity drop-down list, select High, Medium, or Low. The camera reacts to slight
changes in motion or brightness in the motion zone when set to High, while the camera reacts to
big changes in brightness or motion when set to Low.
See relevant instructions in the Alarm section for the following actions:
Store a snapshot, Record the event on the
text, or Set the arming schedule

5.3.1.5.4 Network

The Events Source > Network screen is used for enabling notification in case the network connection is
lost or if there is another device on the network that is using the same IP address as the camera. This
screen enables you to:
·
Sending an alarm if the network connection is lost or if there is a network conflict
·
Recording an event in the camera's microSD card
March 10, 2019
Events Source > Motion Screen
camera, Sending an email
CB-3304/CB-3308 User and Installation Guide
Configuration and Operation
notification, Define OSD
61