FLIR Ariel Gen IIICB-3308 User And Installation Manual page 53

To configure basic settings
1. In the Login ID text box, enter your Login ID number.
Note:
It is recommended, but not necessary, to enable authentication in order to use RTSP.
2. From the Authentication drop-down list, select ON to encrypt the transmission. The default is OFF.
3. In the Password text box, enter your password after selecting Authentication ON.
4. In the Port text box, enter the RTSP network port. The default is 554. The range is 1025 to 65535.
5. From the Auto Connect drop-down list, select ON or OFF. The default is OFF.
To configure the multicast address
1. In the Stream1 section, in the URL text box, enter the RTSP server's URL. The default is stream1.
2. From the Metadata drop-down list, select ON or OFF. The default is OFF.
3. From the Address Type drop-down list, select Manual or Auto. The default is Auto.
4. In the Multicast URL text box, enter the multicast URL. The default is stream1m. Valid multicast
addresses are in the range 224.0.1.1 – 239.255.255.254.
Note:
Switches, routers and devices must be configured to support multicast if this mode is selected.
5. In the Video Address text box, enter the IP address for the RTSP server.
6. In the Video Port text box, enter the network port number for communicating with the RTSP server.
7. In the Meta Address text box, enter the IP address to which the metadata is sent.
8. In the Meta Port text box, enter the network port number for transmitting the metadata.
9. If you are using the second or third stream, in the Stream2 or Stream3 section, repeat the above
steps.
10. Click Save.
March 10, 2019
CB-3304/CB-3308 User and Installation Guide
Configuration and Operation
47