Object Removal - FLIR Ariel Gen IIICB-3308 User And Installation Manual

Basic Settings:
For general "Basic Settings" see
See the following sections for more information on Advanced options and Analytics actions (completion of
rule configuration)
Advanced Options
Analytics Actions
The Video Analytics > Object Removal screen is used for configuring the object removal detection
analytic capability.
This page allows you to:
·
Configure 3 detection areas
·
Reset Max and Min Object size
·
Set removal duration
·
Configure advanced settings, including sensitivity, area masking, reset scene and arming schedule
·
Analytics actions
Use the Object Removed rule to monitor an area for objects that are being taken out of it. For example, a
store or a gallery with specific objects to protect.
On the initial setup step, set minimum and maximum object sizes that correspond to the protected
objects. Draw up to three rectangular zones around the objects.
Once the rule has been defined, do not disturb the scene for about 30 seconds to a minute.
See the Initial Settings
Zone Settings:
This section allows the user to create 3 zones in order to configure the desired detection areas.
Clicking and dragging on the video scene will produce a re-sizable box at can be moved and sized to mark
the desired area for object removal detection
March 10, 2019
Basic Settings
section for more information on the setup process:
CB-3304/CB-3308 User and Installation Guide
Configuration and Operation
85