Fisher & Paykel DCS RGS Series Service Manual page 65

DOOR HINGE ROLLER
An anti-tip device should be installed (see page 15 for in-
structions). Electric and gas connections should be made
before the range is slid into the cabinet opening. If installing
a full backguard with the range it should also be installed
before the range is placed in its fi nal position. For proper
performance, the professional range should be level. To
achieve a fl ush fi t of the range to adjoining countertops, it
will be necessary to have level cabinets (front to back, and
left to right across opening of the range).
After checking the countertops for level and before sliding
the range into place, measure the distance from the fl oor
to the top of the counter work surface in the rear left and
right corners. Adjust the corresponding rear corner of the
range to an equal height of the counter, as the rear level-
ing legs are not accessible once the range is pushed into
place. Once the range is in place, the front leg levelers can
be accessed to level the front of the range. Replace the kick
panel and oven doors by reversing the procedure described
previously. It is important that the two screws retaining the
kick panel are secure to prevent accidental access to live
electrical components and wires.
INSTALLATION INSTRUCTIONS
UNPACKING AND HANDLING
LOCK
(CLOSE)
UN-LOCK
GRIDDLE LEVEL ADJUSTMENTS
The grill and griddle sections (if equipped) are fastened
in place at the front with screws. They are designed to be
stationary and not meant to be removed for cleaning. The
griddle has two leveling screws beneath the rear fl ue cover
which can be used to adjust the griddle to the desired
slope. To access the leveling adjustment screws, remove
the griddle fl ue cover by lifting upwards. The center screw
is for shipping and should be removed.
64