Fisher & Paykel DCS RGS Series Service Manual page 38

REMOVING THE TRANSFORMER & REIGNITION MODULE
5. To remove the reignition module:
a) Pull the primary wiring connector off the reigni-
tion module.
b) Remove the two screws from the reignition mod-
ule and pull the module out as far as possible.
c) Note the wire locations, and then disconnect
the burner wires from the reignition module
and remove the module.
SERVICING THE COMPONENTS
Reignition Module
Burner Wires
Screw
37
Screw
Primary Wire Connector