Removing The 12ʺ Oven Bake Burner, Burner Ignitor, & Thermal Valve - Fisher & Paykel DCS RGS Series Service Manual

REMOVING 12ʺ OVEN BAKE BURNER, BURNER IGNITOR, & THERMAL VALVE
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical
shock.
1. Turn off the gas and disconnect power to the range.
2. Remove the 12ʺ oven door (see page 78 for the door
removal procedure).
3. Remove the racks from the oven.
4. Remove the side rack supports.
5. Remove the two screws from the left and right lower
front rack brackets and remove the brackets (see the
upper right photo).
6. Lift the front of the oven fl oor and slide it out of the
oven.
SERVICING THE COMPONENTS
Side Rack Supports
Lower Front Rack Brackets
7. To remove the 12ʺ oven bake burner:
a) Remove the screw from the rear of the burner.
b) Lift the rear of the burner, pull the air shutter at
the front of the burner off the orifi ce, and remove
the burner.
52
Oven Floor
Rear Burner Screw