Fisher & Paykel DCS RGS Series Service Manual page 92

FRAME, SIDES, DOOR EXTERIOR, HEAT
DEFLECTOR
These parts are made of stainless steel. Follow the direc-
tions for the Backguard. Take care when cleaning the door
top, and do not let water or cleaners run down the vents.
If water or cleaners spill into the vents, they may streak the
glass inside the door.
DOOR GASKET
Use warm soapy water only (no commercial cleaner) and
rub softly, blot dry with a cloth. Do not rub. Do not remove
or damage the mesh.
REPLACING THE OVEN LIGHT BULB
1. Turn off the circuit breaker to the range.
2. Be sure the oven light bulb switch is in the Off position
(the bottom of the switch is pressed in).
3. If necessary, allow the cover and the bulb to cool com-
pletely.
4. Unscrew the cover counterclockwise and remove it.
5. Unscrew the old bulb, and replace it with a new 40 watt
appliance bulb only.
6. Replace the cover.
7. Turn the circuit breaker back on (see Caution).
USE AND CARE
CARE AND MAINTENANCE
POWER FAILURE
The broiler and oven burners cannot be turned on during a
power failure. To light the cooktop burners, turn the control
knob to "LITE", and hold a lighted match to the port ring.
After the fl ame is burning all the way around the burner,
adjust the fl ame. It is necessary to light each burner sepa-
rately, each time you want to use it.
91
CAUTION:
Be sure the oven light switch is in the OFF po-
sition and the cover is cool. If the bulb comes
loose from the base, turn off the power to
the oven at the circuit breaker panel before
attempting to remove the bulb base from
the socket.