Installation Instructions; Introduction - Fisher & Paykel DCS RGS Series Service Manual

IMPORTANT INSTALLATION INFORMATION
The RGS series ranges are tested in accordance with ANSI
Z21.1 Standard for Household Cooking Gas Appliances.
These ranges must be installed in conjunction with a suit-
able overhead vent hood (see "Ventilation Requirements"
on page 14). Due to the professional high heat capacity of
this unit, particular attention should be paid to the hood
and duct work installation to ensure it meets local building
codes. To eliminate the risk of burns or fi re by reaching over
heated surface units, cabinet storage located above the
surface units should be avoided. Check the local building
codes for the proper method of range installation. Local
codes vary.

INSTALLATION INSTRUCTIONS

INTRODUCTION

Installation, electrical connections, and grounding must
comply with all applicable codes. In the absence of local
codes, the range should be installed in accordance with
the National Fuel Gas Code ANSI Z223.1, latest edition, and
National Electrical Code ANSI / NFPA 70, latest edition. Be
sure that the unit being installed is set up for the kind of
gas being used. The gas ranges are shipped from the factory
set and adjusted for natural gas or LP (propane), depend-
ing on the specifi c model ordered. Verify that the range is
compatible with the gas supply at the installation site before
proceeding further. Return the range to the dealer if the unit
is not set for the site gas supply.
61