Fisher & Paykel DCS RGS Series Service Manual page 54

REMOVING 12ʺ OVEN BAKE BURNER, BURNER IGNITOR, & THERMAL VALVE
8. To remove the 12ʺ oven bake burner ignitor and ther-
mal valve:
a) Remove the two screws and nuts from the 12ʺ
oven bake burner ignitor and remove the ignitor
from the bracket.
Burner Ignitor Screws & Nuts
b) Remove the kick panel (see step 8 on page 75).
c) Remove the 5/8ʺ nut and remove the gas line
from the thermal valve.
d) Remove the two nuts from the thermal valve
and remove the valve from the bracket.
Thermal Valve Nuts
Thermal Valve Gas Line Nut
SERVICING THE COMPONENTS
e) Disconnect the two wire connectors from the
thermal valve terminals, and remove the thermal
valve and ignitor.
Thermal Valve Wire Connectors
REASSEMBLY NOTE: When you reinstall the oven
fl oor, do not install the two air adjustment clips
over the front fl ange of the oven fl oor. The clips are
installed below the fl ange, as shown below.
Correct Clip Position
Oven Floor Flange
Air Adjustment Clips
53
Incorrect Clip Position