Settings in TROVIS-VIEW software
2. Double-click the required parameter to open a pop-up window to modify parameter set-
ting.
Right-click the required parameter to open pop-up window to modify parameter settings:
Modify
Opens pop-up window to modify parameter settings.
Read
Uploads parameter value from device.
Write
Downloads parameter value to device.
Default: ... Resets parameter to default setting (setting in gray to indicate that the
parameter value is the same as the default setting)
Min ...
Set parameter to the displayed minimum value.
Max ...
Set parameter to the displayed maximum value
Note: Refer to the code list (section 12 on page 74 onwards) for descriptions of each param-
eter. The code number assigned to a parameter is listed in the Comment column in
TROVIS-VIEW.
13.5 Initializing the positioner
Initializing the positioner is only possible in TROVIS-VIEW when the positioner has been at-
tached properly to the control valve and has been connected (see sections 4 and 5). The
positioner must be connected to the computer over the serial interface adapter.
106
EB 8384-3 EN