Code list
Diagnosis errors
Error codes – Recommended action Condensed state alarm active, when prompted, Err appears.
Extended diagnostics
79
Status classification Maintenance required (cannot be classified)
Diagnostic parameters
80
Status classification Maintenance required (cannot be classified)
Recommended action Confirm error.
Reference graphs
81
Status classification [Maintenance required]
Recommended action Check and, if necessary, perform a new reference test
98
EB 8384-3 EN
When fault alarms exist, they are displayed here.
Alarms are generated by the extended EXPERT
+
EXPERT
has been activated under Code 48
Errors that are not critical for control.
Check and, if necessary, perform a new reference test
An error occurred during plotting the reference graphs for drive
signal y steady-state or drive signal y hysteresis.
• Reference test was interrupted
• Reference line for drive signal y steady-state or drive signal y
hysteresis was not adopted.
Fault alarms are saved in a non-volatile memory. They cannot be
reset.
+
diagnostics if