Data Transmission - Samson 3730 Series Mounting And Operating Instructions

Converting the software version
The TROVIS-VIEW software version must match the firmware of the positioner.
On exchanging data between the positioner and TROVIS-VIEW, the software automatically
checks whether the versions are compatible and, if necessary, converts the data.
If you want to adapt the firmware version without exchanging any data, proceed as follows:
1. Select Convert in the File menu.
A window with a drop-down list of all
the available firmware versions appears.
2. Select the corresponding version.
3. Click on OK button to confirm the se-
lected version.

13.4 Data transmission

Settings performed in the operator interface can be made both when the positioner is con-
nected or not connected. When the positioner is connected, data uploaded from the
positioner can be overwritten.
The default setting appear on the operator interface when no positioner is connected. A
stored TROVIS-VIEW file (*.tro) can be loaded and overwritten by selecting Open in the File
menu.
Connection to the positioner can also be made by clicking the icons on the top right in the
device toolbar:
Data from the positioner are uploaded and shown in the operator interface.
The complete set of data is downloaded to the positioner from the operator interface.
To transfer individual parameters, open the corresponding context-sensitive menu. Select
Write to just download the selected parameter, refer to section 13.4.3.
The positioner is in the online mode, indicated by the TROVIS-VIEW 3 logo on the top
right in blue.
The positioner is in the offline mode.
The listed functions can be activated in the Device menu.
Settings in TROVIS-VIEW software
103
EB 8384-3 EN