Table of Contents
Advertisement
2.1 Overview
This chapter provides advice and instructions for unpacking and preparing your system for
setup. If your system is not already fully integrated with processors, system memory etc.,
refer to
Chapter 3
for details on installing those specific components.
Caution: Electrostatic Discharge (ESD) can damage electronic components. To prevent such
damage to PCBs (printed circuit boards), it is important to use a grounded wrist strap, handle
all PCBs by their edges and keep them in anti-static bags when not in use.
2.2 Unpacking the System
Inspect the box in which the SuperServer SYS-741P-TR/741P-TRT was shipped, and note
if it was damaged in any way. If any equipment appears damaged, file a damage claim with
the carrier who delivered it.
The system should be situated in a clean, dust-free area that is well ventilated. Avoid areas
where heat, electrical noise and electromagnetic fields are generated. It will also require a
grounded AC power outlet nearby. Be sure to read the precautions and considerations noted
in
Appendix
A.
2.3 Preparing for Setup
Please read this section in its entirety before you begin the installation.
Choosing a Setup Location
•
The system should be situated in a clean, dust-free area that is well ventilated. Avoid areas
where heat, electrical noise and electromagnetic fields are generated.
•
This product is not suitable for use with visual display workplace devices according to §2
of the German Ordinance for Work with Visual Display Units.
Rack Precautions for the Optional Rack Mount Kit
•
Ensure that the leveling jacks on the bottom of the rack are extended to the floor so that
the full weight of the rack rests on them.
Chapter 2
System Installation
21
Chapter 2: System Installation
Advertisement
Table of Contents
Troubleshooting
