Table of Contents
Advertisement
Hot-Swap Drives
Hot-swap capability depends on the operating system support. Check if a drive is hot-
swappable before attempting to remove the drive. If a drive is not hot-swappable, power down
the system and remove power before opening the front bezel.
Removing a Drive Carrier
1. Open the front bezel then push the release button located beside the drive LEDs.
2. Swing the handle fully out and then use it to pull the unit straight out.
3. The drive is located on the underside of the unit. Turn the unit over to install or remove
the drive. A 3.5-to-2.5 inch converter tray is pre-installed in the drive carrier.
Installing 2.5" Drive into the Converter Tray
1. Fit one side of the drive against the release lever.
2. Press the other side of the drive down until it clicks into place.
Figure 3-9. Mounting a 2.5" Drive into a Carrier
Chapter 3: Maintenance and Component Installation
Figure 3-8. Removing a Drive Carrier
70
Advertisement
Table of Contents
Troubleshooting
