Installing The Phm Into The Cpu Socket - Supermicro SuperServer SYS-741P-TR User Manual

Installing the PHM into the CPU Socket

1. Align peek nut (marked A) on the heatsink against threaded fastener (marked a) on the
CPU socket. Then align peek nuts (marked B, C, D) on the heatsink against threaded
fasteners (marked b, c, d) on the CPU socket, making sure that all peek nuts on the
heatsink are properly aligned with the correspondent threaded fasteners on the CPU
socket.
2. Once they are aligned, gently place the heatsink on top the CPU socket, making sure
that each peek nut is properly attached to its corresponding threaded fastener.
3. Press all four rotating wires outwards and make sure that the heatsink is securely
latched onto the CPU socket.
4. With a T30 screwdriver, tighten all peek nuts in the sequence of A, B, C, and D with
even pressure. To avoid damaging the processor or socket, do not use excessive force
when tightening the peek nuts. (For best durability, 8in-lbf torque is recommended.)
5. Examine all corners of the heatsink to ensure that the PHM is firmly attached to the
CPU socket.
Chapter 3: Maintenance and Component Installation
B
A, B, C, D:
Peek Nut on the Heatsink
D
b
d
a, b, c, d:
Threaded Fastener on the CPU socket
2U Heatsink
2U Heatsink
53
C
A
c
a
Latched State