Preparing To Install The Phm Into The Cpu Socket - Supermicro SuperServer SYS-741P-TR User Manual

Preparing to Install the PHM into the CPU Socket

After assembling the Processor Heatsink Module, you are ready to install it into the CPU
socket. To ensure the proper installation, please follow the procedures below:
1. Locate four threaded fasteners (marked a, b, c, and d) on the CPU socket.
d
2. Locate four peek nuts (marked A, B, C, and D) and four rotating wires (marked 1, 2, 3,
and 4) on the heatsink as shown below.
A, B, C, D: Peek Nut
1, 2, 3, 4: Rotating Wire
a, b, c, d: Threaded Fastener
Rotating Wire
Rotating Wire
Peek Nut
(Unlatched)
(Latched)
Chapter 3: Maintenance and Component Installation
CPU Socket
c
a
(a, b, c, d: Threaded Fasteners)
Rotating Wire 2
B
4
D
b
d
CPU1/CPU2 Socket
2U Heatsink
51
b
CPU Socket Pin1
Rotating Wire
C
Rotating Wire 1
A
Peek Nut
c
a
3