Advertisement
Maintenance
Install the seat stopper [1], back-up ring [2] and spring
seat collar [3] to the fork damper in the shown direction.
• Install the back-up ring with its black coated side
facing the seat stopper.
[1]
[3]
Blow out the oil off completely from the fork spring and
damper.
Apply recommended fork oil to the spring seat collar
bushing [1].
Put the fork spring [2] on the fork damper [3].
Put the fork damper/spring into the fork assembly [4].
[3]
[2]
2-70
[2]
[1]
[2]
[3]
[1]
[4]
Hold the outer tube [1] and temporarily tighten the fork
damper [2] using the special tool.
TOOL:
Lock nut wrench, 50 mm [3] 07WMA-KZ30100
[2]
[1]
Set the axle holder [1] of the slide pipe in a vise with
pieces of wood or soft jaws to avoid damage.
• Do not over-tighten the vise on the axle holder.
Push the outer tube until the fork center bolt lock nut [2] is
fully exposed and install the special tool or mechanic's
stopper tool between the axle holder and lock nut.
TOOL:
Piston base [3]
U.S.A. TOOL:
Fork rod stopper
• Be careful not to damage the piston rod.
Install the push rod [4] into the piston rod [5] until it stops.
• Check the push rod installation by turning the push rod
right and left.
[1]
[2]
[3]
07958-2500001
07AMB-KZ3A100
[3]
[5]
[4]
Advertisement
