Advertisement
LICENSE LIGHT COVER
REMOVAL/INSTALLATION
Remove the license light cover bolts [1] and trim clip [2].
Release the license light wire grommet [3] from the
license light cover [4].
Remove the license light cover.
Remove the spring nuts [5] from the license light cover.
Installation is in the reverse order of removal.
TORQUE:
License light cover bolt:
5.2 N·m (0.5 kgf·m, 3.8 lbf·ft)
• Route the wire properly as shown.
[3]
[1]
[4]
[1]
[2]
[5]
REAR FENDER B
REMOVAL/INSTALLATION
Remove the following:
– Rear fender A 1-10
– License light cover 1-11
Disconnect the battery negative (–) cable 1-13.
Remove the fuse box [1] from the fuse box cover [2].
Disconnect the regulator/rectifier 5P (Black) connector
[3].
Remove the bolts [4] and regulator/rectifier [5].
Remove the cover [6].
Disconnect the starter relay switch 4P connector [7].
Remove the starter relay switch terminal bolt [8] and
starter motor cable [9].
Remove the starter relay switch terminal bolt and battery
positive (+) cable [10].
Remove the starter relay switch [11].
Remove the bolt [12] and fuse box cover.
Release the main wire harness [13] from the fuse box
cover tab [14].
Installation is in the reverse order of removal.
TORQUE:
Starter relay switch terminal bolt:
7.0 N·m (0.7 kgf·m, 5.2 lbf·ft)
[7]
[12]
[6]
[3]
[5]
[4]
[8]/[10]
Frame/ Body Panels
[1]
[2]
[14]
[13]
[8]/[9]
[11]
1-11
Advertisement
