Advertisement
Frame/ Body Panels
Disconnect the IAT sensor 2P (Black) connector [1].
Remove the nut [2] and release the wire stay [3].
Release the open air hose [4] from the guide [5].
[1]
[3]
Loosen the connecting hose band screw [1] and
disconnect the air cleaner housing [2] from the
connecting hose [3].
[1]
[3]
Remove the rear frame upper bolts [1] and rear frame
lower bolts [2].
Remove the rear frame [3] with the air cleaner housing.
[1]
[2]
1-14
[4]
[5]
[2]
[2]
Align
[1]
[2]
[3]
Installation is in the reverse order of removal.
TORQUE:
Rear frame upper bolt:
32 N·m (3.3 kgf·m, 24 lbf·ft)
Rear frame lower bolt:
49 N·m (5.0 kgf·m, 36 lbf·ft)
Battery terminal bolt:
2.0 N·m (0.2 kgf·m, 1.5 lbf·ft)
• Tighten the rear frame upper bolts first, then the lower
bolts.
• Align the tab of the air cleaner housing with the index
mark of the connecting hose.
• Tighten the connecting hose band screw [1] to the
specified range as shown.
15°
[1]
Up
Left
6 – 9 mm
(0.2 – 0.4 in)
Advertisement
