Advertisement
Apply specified grease to the throttle cable ends and
throttle pipe flange groove 2-6.
Put the throttle pipe on the handlebar.
Connect the throttle cables [1] to the throttle pipe [2].
Install the wire guides [3] onto the throttle housings [4].
• Align the lug of the wire guides with the groove of the
throttle housings.
Install the throttle housings and bolts [5].
• Be careful not to pinch the throttle wires by the
housings.
• Do not tighten bolts yet.
[1]
Align
[4]
Align
(Specified grease)
[2]
(Specified grease)
[3]
[5]
[4]
Align the throttle housings [1] end with the paint mark on
the handlebar.
Tighten the upper bolt [2] first, then the lower bolt [3].
Install the dust cover [4].
Adjust the throttle grip freeplay 2-18.
Be sure the throttle returns freely from fully open to fully
closed automatically, in all steering positions.
If the throttle operation is not smooth, replace the cable.
[4]
Align
CLUTCH CABLE LUBRICATION
Release the clutch lever cover [1].
Turn the adjuster [2] and remove the clutch cable [3].
Disconnect the clutch cable from the clutch lever [4].
Thoroughly lubricate the cable end [5] with grease.
• It is not necessary to lubricate the entire cable.
Connect the clutch cable end to the lever.
Install the clutch cable and turn the adjuster.
[1]
[2]
[3]
Maintenance
[1]
[2]
[3]
[4]
[5]
2-61
Advertisement
