Advertisement
Install the spring seat [1] and judder spring [2] as shown.
Coat the clutch disc lining surfaces with clean engine oil.
Install the clutch disc A (larger I.D. disc) [3].
Install the six clutch plates [4] and five clutch discs B [5]
alternately, starting with the clutch plate.
• Align the clutch plates larger grooves [6] with the
larger lugs [7] of the clutch center as shown.
Install the clutch disc C [8].
• Install the clutch disc C tabs into the shallow slots of
the clutch outer [9] as shown.
[9]
[8]
[4]
[3]
[8]
[8]
[5]
[6]/[7]
[2]
[1]
[1]
[2]
[5]
[3]
Insert the clutch lifter rod [1] into the mainshaft.
• Check the lifter rod installation by turning the clutch
lifter arm.
Apply engine oil to the bearing area of the clutch lifter
piece.
Install the clutch lifter piece [2].
Install the clutch pressure plate [1].
Install the clutch springs [2] and clutch spring bolt/
washers [3].
Tighten the clutch spring bolt/washers to the specified
torque in a crisscross pattern in two or three steps.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
[1]
Maintenance
[1]
[2]
[2]/[3]
2-59
Advertisement
