Advertisement
RIGHT CRANKCASE OVER
COVER
REMOVAL/INSTALLATION
Remove the lock pin [1] from brake pedal pivot bolt [2].
[1]
[2]
Remove the brake pedal pivot bolt [1] and washer [2].
Remove the dust seals [3] from the brake pedal.
[1]
[2]
[1]
[2]
Front
[3]
[3]
Remove the bolt A [1], bolts B [2], bolts C [3], and right
crankcase over cover [4].
Installation is in the reverse order of removal.
TORQUE:
Brake pedal pivot bolt:
36 N·m (3.7 kgf·m, 27 lbf·ft)
• Apply specified grease to the dust seal lips 2-6.
• Install the dust seals to the brake pedal with its lip side
facing out as shown.
• Replace the dust seals with new ones if they are
damaged or deteriorated.
• Apply molybdenum disulfide grease to the brake pedal
pivot bolt sliding surface.
• Check that the lock pin is seated in the groove of the
brake pedal pivot bolt securely.
[1]
[4]
MUD GUARD
REMOVAL/INSTALLATION
Remove the mud guard screws [1], washers [2], and mud
guard [3].
Installation is in the reverse order of removal.
TORQUE:
Mud guard screw:
1.5 N·m (0.2 kgf·m, 1.1 lbf·ft)
[3]
Frame/ Body Panels
[2]
[3]
[1]/[2]
1-9
Advertisement
