Advertisement
Frame/ Body Panels
Disconnect the following connectors:
– Brake/taillight 3P [1]
– License light 2P [2]
– Left turn signal light 2P (Orange) [3]
– Right turn signal light 2P (Light blue) [4]
Remove the following:
– Number plate bracket bolts A (6 x 22 mm) [5]
– Flange collars A [6]
– Number plate bracket bolts B (8 x 20 mm) [7]
– Flange collars B [8]
– Number plate bracket [9]
Release the following from the rear fender B [10]:
– Wire band [11]
– DLC [12]
– Wire clip [13]
Remove the rear fender B.
[12]
[11]
[13]
Align
[4]
[8]
[6]
[10]
1-12
[1]
[3]
[9]
[2]
[5]
[7]
Disconnect the license light 2P connector [1].
Remove the license light screw/washers [2] and nuts [3].
Release the wire clip [4].
remove the license light unit [5].
Installation is in the reverse order of removal.
TORQUE:
Number plate bracket bolt B:
26 N·m (2.7 kgf·m, 19 lbf·ft)
License light screw/washer:
2.0 N·m (0.2 kgf·m, 1.5 lbf·ft)
• Route the wire properly as shown.
• Replace the license light screw/washers with new
ones.
• Align the rear fender B tabs with the air cleaner
housing grooves.
[4]
[5]
[2]
[3]
[1]
[1]
Advertisement
