Advertisement
Maintenance
Loosen the fork bottom bridge pinch bolts [1] and pull the
fork leg [2] down and out.
FORK TUBE OIL DRAINING
Remove the front fork 2-64.
Clean the following before disassemble the fork.
– Fork assembly
– Bottom of the slider around the center bolt
– Sliding surface of the slide pipe
• Be careful not to scratch the slide pipe.
• Be careful not to damage the dust seal.
Measure and record the length between the axle holder
and outer tube before disassembling the fork.
2-66
[1]
[2]
Hold the outer tube [1] and remove the fork damper [2]
using the special tool from the outer tube.
TOOL:
Lock nut wrench, 50 mm [3] 07WMA-KZ30100
Slide the outer tube down onto the axle holder.
[2]
[1]
Drain the fork oil from the inside of the fork tube and fork
damper oil holes by pumping the fork several times.
Remove the O-ring [1] from the fork damper.
[3]
[1]
Advertisement
