Advertisement
HANDLE POSITION
HANDLEBAR LOWER HOLDER
POSITION ADJUSTMENT
The position of the handlebar can be changed by
exchange it with the optional handlebar lower holder, or
by changing the install direction of the standard
handlebar lower holder.
• The standard handlebar position is offset to 3.0 mm
(0.1 in) forward from the center axis of the lower
holder.
• By turning the standard handlebar lower holder 180°,
the handlebar position will be moved 6.0 mm (0.2 in)
rearward of the standard position.
LOWER HOLDER
Standard position
Standard
3 mm rearward
6 mm rearward
Standard
For exchange or change the install direction of the
handlebar lower holder, refer to the following:
180° TURN
STANDARD
LOWER
HOLDER
Remove the handlebar pad [1].
LOWER HOLDER
DIRECTION
Forward
Optional
–
Rearward
OPTIONAL
LOWER
HOLDER
POSITION
STANDARD
LOWER
HOLDER
POSITION
[1]
Loosen the handlebar lower holder nuts [1].
Remove the rear handlebar upper holder bolts [2], front
handlebar upper holder bolts [3], handlebar upper
holders [4] and handlebar [5].
Remove the handlebar lower holder nuts and washers
[6].
Turn or exchange the handlebar lower holders [7].
Temporarily install the washers and handlebar lower
holder nuts.
Place the handlebar on the handlebar lower holders.
Install the handlebar upper holders with its punch mark
[8] facing forward.
Install and tighten the front handlebar upper holder bolts
to the specified torque.
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft)
• Align the paint mark on the handlebar with the top
surface of the handlebar lower holders.
Install and tighten the rear handlebar upper holder bolts
to the specified torque.
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft)
• Tighten the front handlebar upper holder bolt first.
Tighten the handlebar lower holder nuts to the specified
torque.
TORQUE: 44 N·m (4.5 kgf·m, 32 lbf·ft)
[3]
[8]
[4]
Align
[7]
Setting Information
[2]
[3]
[8]
[4]
[5]
[2]
[1]/[6]
[7]
3-3
Advertisement
