Advertisement
Clamp the brake hose and wheel speed sensor wire with
the brake hose clamps [1].
Install the clamps and brake hose clamp bolts [2].
Tighten the brake hose clamp bolts to the specified
torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
• Align the brake hose protector end with the hose
clamp end as shown.
Install the handlebar 2-75.
Inspect the wear rings direction 2-62.
Adjust the front fork air pressure to atmospheric pressure
3-4.
[1]
Align
HANDLEBAR INSTALLATION
Temporarily install the bushings [1], handlebar lower
holders [2], washers [3] and handlebar lower holder nuts
[4].
Place the handlebar [5] on the handlebar lower holders.
Install the handlebar upper holders [6] with its punch
mark [7] facing forward.
Install and tighten the front handlebar upper holder bolts
[8] to the specified torque.
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft)
• Align the paint mark on the handlebar with the top
surface of the handlebar lower holders.
Install and tighten the rear handlebar upper holder bolts
[9] to the specified torque.
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft)
• Tighten the front handlebar upper holder bolt first.
Tighten the handlebar lower holder nuts to the specified
torque.
TORQUE: 44 N·m (4.5 kgf·m, 32 lbf·ft)
[2]
[6]
Align
[2]
[1]
Install the handlebar pad [1].
Maintenance
[8]
[7]
[9]
[8]
[3]/[4]
[1]
[7]
[6]
[5]
[9]
[2]
[1]
2-75
Advertisement
