Advertisement
REAR:
Remove the following:
– Rear master cylinder reservoir cover bolts [1]
– Reservoir cover [2]
– Set plate [3]
– Diaphragm [4]
Fill the reservoir with recommended brake fluid to the
upper level line [5].
RECOMMENDED BRAKE FLUID:
Honda DOT 4 brake fluid
Install the diaphragm, set plate, and reservoir cover.
• Do not bend the diaphragm during installation.
Install and tighten the rear master cylinder reservoir
cover bolts to the specified torque.
TORQUE: 1.5 N·m (0.2 kgf·m, 1.1 lbf·ft)
Inspect the hydraulic system 2-54.
[1]
[2]
[3]
[4]
[5]
[4]
BRAKE PADS WEAR
Inspect the brake pads.
If either pad is worn anywhere to a thickness of 1.0 mm
(0.04 in), both pads must be replaced.
• The width of wear indicator [1] is 1.0 mm (0.04 in).
Replace the brake pad if it is wear to the service limit.
Refer to an official Honda Service Manual or see your
dealer to replace the brake pads.
Front:
[1]
Rear:
[1]
Maintenance
1.0 mm
(0.04 in)
[1]
1.0 mm
(0.04 in)
1.0 mm
(0.04 in)
[1]
2-53
Advertisement
