Club Car Carryall 300 2018 Maintenance And Service Manual page 80

6
Brake Shoe Installation
1
646
Figure 6-14 Install Leading Shoe
6. Place a flatblade screwdriver under the adjusting arm (1) and raise the arm off of the adjusting wheel (2). While
holding the arm (1) up, turn the wheel (2) upward until it stops (Figure 6-16, Page 6-8). Arm must engage teeth
of the wheel. Remove the screwdriver.
648
Figure 6-16 Set Adjusting Wheel
7. For electric vehicles: Install the axle shaft. See Axle Shaft and Oil Seal Installation, Section 17, Page 17-4.
For gasoline vehicles: Install the wheel hub assembly. See Rear Hub Installation, Section 26, Page 26-4.
8. Install the brake drum, and make sure that it is properly seated. See following NOTE.
NOTE: If drum installation is difficult, the brake shoes may need to be adjusted vertically in the mounting slots.
9. After the drum is installed, make sure the axle and drum turn freely and then install the wheel. See Wheel
Installation on page 8-1.
10. Connect the battery cables. See Connecting the Batteries – Electric Vehicles, Section 1, Page 1-4.
See Connecting the Battery- Gasoline Vehicles on page 1-3.
Page 6-8 2018 Carryall 300 Maintenance and Service Manual
A
647
2
1
WHEEL BRAKE ASSEMBLIES
Figure 6-15 Check Shoe Positions