Club Car Carryall 300 2018 Maintenance And Service Manual page 74

6
Brake Shoe Removal
2
4
1400-18100-10209
Figure 6-1 Loosen Brake Cables
5.2. Insert a 1/2 inch x 5/8 inch (1.27 x 1.58 cm) cold chisel (1) under the head of each pin (2) and shear them
off as illustrated (Figure 6-2, Page 6-2). This will release the brake shoes from the backing plate, allowing
them to pivot away from the inside of the brake drum (3), and allow the brake drum to be pulled free. After
completing step 6, skip step 7. See following NOTE.
NOTE: Although step 6 allows easier access to the brake shoes, it is not imperative to do so in order to remove
the brake shoes.
6. For electric vehicles: Remove the axle shaft. See Axle Shaft and Oil Seal Removal, Section 17, Page 17-1.
For gasoline vehicles: Remove the wheel hub assembly. See Rear Hub Removal, Section 26, Page 26-4.
7. Using needle nose pliers, rotate the clip retainer pin (1) 90° to remove the shoe retainer clip (2) (Figure 6-3, Page
6-3). See following CAUTION.
CAUTION
• The brake shoes are under pressure and can release suddenly when brake shoe retainers are removed.
8. Grasp both brake shoes and pull them, together with the springs, out of the brake assembly as shown (Figure
6-4, Page 6-3).
9. Remove the adjuster wheel (1) and two washers (2 and 3) from the backing plate (Figure 6-5, Page 6-3).
Page 6-2 2018 Carryall 300 Maintenance and Service Manual
1
3
1
1400-18100-10220
Figure 6-2 Shoe Retainer Pins
WHEEL BRAKE ASSEMBLIES