Voltage Limiter Removal; Voltage Limiter Installation - Club Car Carryall 300 2018 Maintenance And Service Manual

ELECTRICAL COMPONENTS: PEDAL-START
GAS VEHICLE
See Test Procedure 27 – Voltage Limiter on page 18-42.

VOLTAGE LIMITER REMOVAL

NOTE: Battery will charge reducing the voltage going to accessories.
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in the NEUTRAL position.
Chock the wheels.
2. Disconnect battery and spark plug wire(s). See Disconnecting the Battery- Gasoline Vehicles on page 1-3.
3. Remove the cowl. See Cowl Removal, Section 4, Page 4-5.
4. The voltage limiter is located on the driver side cowl frame.
5. Disconnect wires from the voltage limiter (1). Do not allow wires to touch (Figure 20-23, Page 20-29).
6. Remove the mounting hardware (2) from the voltage limiter and remove from vehicle.

VOLTAGE LIMITER INSTALLATION

1. Mount the voltage limiter to the driver side frame using the mounting hardware and tighten to 25 in·lb (2.8
N·m) (Figure 20-23, Page 20-29).
2. Connect the black wire from harness to the black wire from limiter.
3. Connect the green wire from the harness to the green wire from the limiter.
4. Install the cowl. See Cowl Installation, Section 4, Page 4-5.
5. Connect battery and spark plug wire(s). See Connecting the Battery- Gasoline Vehicles on page 1-3.
2
3002
Figure 20-23 Voltage Limiter
4
1
2018 Carryall 300 Maintenance and Service Manual
20
Voltage Limiter
Page 20-29