Tools Required For This Section - Club Car Carryall 300 2018 Maintenance And Service Manual

TRANSAXLE (ED65): GASOLINE VEHICLES
3. Use a funnel when filling the transaxle through the lubricant level indicator hole. Fill with 67.6 fl-oz (2 L) 80-90
WT. API class GL or 80-90 WT. AGMA class 5 EP gear lubricant (or until lubricant begins to run out of the
level indicator hole).
4. Install upper plug and gasket and tighten to 17 ft·lb (23 N·m).
3055
Figure 26-2 Lubricant Level Plug and Drain Plug

TOOLS REQUIRED FOR THIS SECTION

_
Hydraulic floor jack (or chain hoist)
Jack stands (2) (one ton capacity)
Standard slip joint pliers
External snap ring pliers (.0.047- in. tip)
90° Internal snap ring pliers (0.090-in. tip)
16-in. rolling head prybar
Plastic or rubber mallet
Ratchet wrench, 3/8-in. drive
Torque wrench, 3/8-in. drive
3/8-in. socket, 3/8-in. drive
7/16-in. socket, 3/8-in. drive
1/2-in. socket, 3/8-in. drive
9/16-in. socket, 3/8-in. drive
5/8-in. socket, 3/8- in. drive
Axle seal tool (CC P/N 1014162)
7/16-in. combination wrench
2018 Carryall 300 Maintenance and Service Manual
General Information
1/2-in. combination wrench
9/16-in. combination wrench
Small flat blade screwdriver
Medium flat blade screwdrivers (2)
No. 2 phillips-head screwdriver
1/4-in. nut driver
5/16-in. nut driver
26
Page 26-3