Club Car Carryall 300 2018 Maintenance And Service Manual page 303

TROUBLESHOOTING AND ELECTRICAL
SYSTEM: PEDAL-START GAS VEHICLE
TEST PROCEDURE 9 – Maintenance/Operate Switch – Pedal-Start Vehicles
See General Warnings on page 1-1.
NOTE: This is a continuity test.
The Maintenance/Operate Switch is also known as the Neutral Lockout Switch.
1. If necessary, see Testing Basics on page 18-14.
2. Remove wires from switch (Figure 18-11, Page 18-27).
3. With switch in position 1 (MAINTENANCE):
3.1. Check for no continuity between terminals T1 and T2.
3.2. Check for continuity between terminals T2 and T3.
4. With switch in position 2 (OPERATE):
4.1. Check for no continuity between terminals T2 and T3.
4.2. Check for continuity between terminals T1 and T2.
1
T1
Toggle Position Operates:
3. T1 – Black/Pink Stripe, T2 – Black, T3 – Black/Yellow Stripe
478
Figure 18-11 Maintenance/Operate Switch Test – for
Pedal-Start Vehicles
5. If switch:
5.1. does not work as stated in previous steps, replace switch.
5.2. does work as stated and the MAINTENANCE/OPERATE modes still do not work:
– Check the limit switches.
– Check continuity of the wires involved.
2
T2 T3
1. Position 1 (MAINT.)
closes T2 to T3
2. Position 2 (OP.) closes
T1 to T2
2018 Carryall 300 Maintenance and Service Manual
18
Test Procedures
Page 18-27