Solenoid; Testing The Solenoid; Solenoid Removal; Solenoid Installation - Club Car Carryall 300 2018 Maintenance And Service Manual

13

Solenoid

SOLENOID
See General Warnings on page 1-1.
The solenoid is located on the driver side of the electrical component mounting plate.

TESTING THE SOLENOID

7 – Solenoid Activating Coil

SOLENOID REMOVAL

1. Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles,
Section 1, Page 1-4.
2. Lift cargo bed.
3. Disconnect all wires from the solenoid (3) (Figure 13-4, Page 13-6).
4. Slide solenoid (3) up to disengage the mounting tabs and remove from component mounting plate.
7
8
2971

SOLENOID INSTALLATION

1. Mount solenoid (3) onto component mounting plate by engaging slot (Figure 13-4, Page 13-6).
2. Using the wiring diagram, install the wires, pre-charge resistor (9), washers (8), and nuts (7) onto the large
mounting posts. Tighten nuts to 77 in·lb (8.7 N·m). (Figure 12-1, Page 12-4).
3. Install the blue/white and light blue wires onto the small terminals of the solenoid.
4. Lower cargo bed.
5. Connect the batteries. See Connecting the Batteries – Electric Vehicles, Section 1, Page 1-4.
Page 13-6 2018 Carryall 300 Maintenance and Service Manual
9
3
Figure 13-4 Solenoid
ELECTRICAL COMPONENTS: ELECTRIC
VEHICLES