Club Car Carryall 300 2018 Maintenance And Service Manual page 396

23
Engine Control Linkages
CAUTION
• Inspect the limit switches inside the electrical component box. If a limit switch lever is bent, replace
the switch.
3113
Figure 23-6 Accelerator Cable Cam Position – 7° (Top
7. Before tightening the jam nuts (3), set the park brake to the first latch and pawl position and check for proper
activation of switches.
8. While pressing the accelerator pedal, the following events should occur in exactly the order shown:
NOTE: Always perform a visual check to ensure the starter motor begins rotating the engine prior to the throttle
body lever moving.
_
Solenoid activation and engine start
Throttle body actuation
9. While holding the accelerator ball joint with pliers, tighten the jam nuts against the ball joints, accelerator ball joint
first, at each end of the accelerator rod.
10. Check rod adjustment for proper switch activation.
11. After the pedal group and accelerator rod are properly adjusted, adjust the engine RPM setting. See Engine
RPM Adjustment on page 23-12.
12. Install the electrical component box cover and tighten retaining screw to 18 in·lb (2.0 N·m).
13. Connect battery and spark plug wire(s). See Connecting the Battery- Gasoline Vehicles on page 1-3.
Page 23-8 2018 Carryall 300 Maintenance and Service Manual
View)
EVENT
Park brake release
FUEL SYSTEM: GASOLINE VEHICLES
3043
Figure 23-7 Governor Cable At Throttle Body
APPROXIMATE PEDAL TRAVEL
15° and greater
3
0° to 4°
4° to 15°
1