Governor Cable - Club Car Carryall 300 2018 Maintenance And Service Manual

FUEL SYSTEM: GASOLINE VEHICLES

GOVERNOR CABLE

Governor Cable Removal
1. Turn the key switch to the OFF position and remove the key, place the Forward/Reverse handle in the NEUTRAL
position, and chock the wheels.
2. Disconnect battery and spark plug wire(s). See Disconnecting the Battery- Gasoline Vehicles on page 1-3.
3. At engine:
3.1. If equipped, remove air deflector from top of engine.
3.2. Disconnect "Z" fitting of governor cable (1) from throttle lever (2) (Figure 23-7, Page 23-8).
3.3. Unsnap governor cable (1) from throttle body bracket (3).
4. At transaxle:
4.1. Disconnect "Z" fitting of governor cable (1) from governor arm (4) (Figure 23-8, Page 23-9).
4.2. Loosen jam nuts at governor bracket (5) and remove cable (1) from vehicle.
1
3110
Figure 23-8 Governor and Accelerator Cables At Governor
Governor Cable Installation and Adjustment
1. At engine:
1.1. Snap governor cable (1) into throttle body bracket (3) (Figure 23-7, Page 23-8).
1.2. Connect "Z" fitting of governor cable (1) to throttle lever (2).
1.3. If equipped, install air deflector on top of engine.
2. At transaxle:
2.1. Slide bellows off threaded end of cable housing, separate jam nuts and place threaded end into governor
bracket (5) (Figure 23-8, Page 23-9).
2.2. Finger-tighten jam nuts.
2.3. Push bellows back onto threaded end of cable housing.
2.4. Connect "Z" fitting of governor cable (1) to governor arm (4).
3. Loosen adjustment screw jam nut (6) and back off throttle stop screw (7) several turns (Figure 23-9, Page 23-9).
4. Rotate governor arm (4) counterclockwise until it stops and hold in this position (Figure 23-9, Page 23-9).
8
9
13
Arm
2018 Carryall 300 Maintenance and Service Manual
Engine Control Linkages
A = 0.055 in. ± 0.039 (1.4 mm ± 1)
3111
Figure 23-9 Throttle Stop Screw Gap
23
Page 23-9