Software - Quantum SuperLoader 3 User Manual

Software

3
Before you enable the Auto Clean option, you must designate which slot
contains the cleaning cartridge and load the cleaning cartridge into that
slot. If you have not done this, the SuperLoader will not allow you to
enable Auto Clean.
To Set Auto Clean:
1 On the main menu, scroll to
2 On the Configuration submenu, scroll to
.
Enter
3 On the Cleaning Tape submenu, scroll to
Clean is enabled, the menu item appears as
clean is disabled, it appears as
4 To change the setting, press the up or down scroll key once, then
press .
Enter
Set the cleaning option in your software application (if available) so that
the software monitors drive cleaning. If your application software
supports automatic cleaning, store a cleaning cartridge in the slot
specified by the application.
SuperLoader User's Guide
Chapter 3 Tape Cartridge Use
Tape Drive Cleaning Methods
, then press
Configuration
Cleaning Tape
Auto Clean On/Off
Auto Clean On
.
Auto Clean Off
3
.
Enter
, then press
. If Auto
. If Auto
67