Sequential Mode
Operations
2
2 On the Configuration menu, scroll to
The mode options appear. A check mark appears next to the
currently enabled mode.
3 Do one of the following:
•
To leave the mode the same, press
•
To modify the change mode, scroll to the mode to which you
want to set the SuperLoader and press
appears on the LCD.
mode
•
Press and hold the power button on the front panel until
System Shutdown Please Wait
appears on the LCD and the SuperLoader shuts off.
•
Press the power button again to power up the SuperLoader.
The new control mode is now in effect.
When you enable
Note:
longer appears on the SCSI bus; only the tape drive
appears.
If you enable
Sequential Mode
under the Commands menu to operate the SuperLoader after you reboot.
•
The
command allows you to load the first cartridge.
Start
•
The
command allows you to continue from the next unused
Resume
slot, if a user stopped the cycle.
•
The
command allows you to stop the cycle.
Stop
SuperLoader User's Guide
Chapter 2 Installation and Configuration
Setting the Change Mode
Change Mode
.
Escape
Enter
appears on the LCD.
, the loader device no
Sequential Mode
, you must use the Sequential Ops submenu
, then press
.
Enter
.
Reboot to enable new
Power Off
47