Set The Cleaning Mode; Set The Magazines - Quantum SuperLoader 3 User Manual

Set the Cleaning
Mode 4

Set the Magazines

4
To enable the
Auto Clean
the cleaning tape cartridge. If a slot has not been designated, the box
displays .
None
To designate the cleaning tape slot:
1 Load a cleaning tape into an empty slot using the Commands page
(see Commands Menu
2 Enable
Auto Clean
If
Note:
Auto Clean
automatically ejected via the mailslot.
To Set Auto Clean:
1 On any On-board Remote Management page, click
2 If a check mark appears in the box next to
enabled. To disable AutoClean, click the box to remove the check
mark.
If no check mark appears in the box next to
disabled. To enable
3 Click .
submit
This setting is used to report the number of storage elements and the
element address to the SCSI host. This setting must match the physical
configuration in order for correct information to be reported. This setting
only affects the information reported to the SCSI host. This setting does
not affect the access to magazines slots from the front panel or On-board
Remote Manager. Those interfaces are based on the physical
configuration.
When configured for
storage elements to the SCSI host. This allows the removal and reinstall of
magazines without affecting what is reported to the host. When
configured for or
Left
storage elements to the SCSI host.
SuperLoader User's Guide
Chapter 4 SuperLoader Operation
function, you must also designate a full slot for
on page 74).
.
is disabled, the cleaning tape will be
, click the box to enter a check mark.
Auto Clean
magazines, the SuperLoader always reports 16
Both
, the SuperLoader will always report eight
Right
Configurations Page
Configurations
, the option is
Auto Clean
, the option is
Auto Clean
4
4
.
113