Set Security Options - Quantum SuperLoader 3 User Manual

Chapter 4 SuperLoader Operation
Configurations Page
Set Security
Options 4
118
3 If a check mark appears in the box next to
address option is enabled. To set a static IP address:
Clear the check box to remove the check mark.
a
In the IP address fields, type the static IP address, using the
b
key to move from box to box.
4 If no check mark appears in the box next to
Configuration Protocol), the static IP address option is enabled. To
change a static IP address, type in the new address in the IP address
fields using the
Tab
5 To change the IP address from a static address to a dynamic address,
click the box next to DHCP.
6 To change the values of the subnet mask, gateway, Simple Network
Management Protocol (SNMP) server, or the time server, type in the
new address, using the
7 Click . You must perform a system reset before the new IP
submit
address takes effect, or you can use the front panel to power cycle
your machine.
When you enable the security option, users must enter a password to
access the SuperLoader's front panel functionality. A password allows
either administrator-level access or operator-level access (see
Security on page 49).
To Set the Security Option:
1 On any On-board Remote Management page, click
from the banner.
2 On the secondary menu, click
SuperLoader User's Guide
key to move from box to box.
key to move from box to box.
Tab
(see
Security
, the dynamic IP
DHCP
(Dynamic Host
DHCP
Setting
Configurations
figure 84).
Tab
4