Suggested
Actions
5
A501: SDLT Hard Write Error
Figure 115 Hard Read
Error/Hard Write Error
Block Descriptor
Long Word
1
2
3
4-12
13
Following is a list of suggested actions:
•
Verify if multiple events on the same media occur, or multiple events
on different media occur. With this information you can determine if
the failures is media caused or drive caused.
•
Make sure the event is not due to media being written badly by some
other drive. To confirm the media was not written incorrectly, look
for A401 events with the same media ID on this drive and other
drives this media may have been written to.
If the drive logs this error, the cleaning light may be turned
Note:
on recommending a cleaning as well.
•
Run a Tape Drive Write/Read test with two pieces of media. If test
fails, replace the DCA.
Write Error is an event is which the tape drive detected a condition that
the drive was not successfully able to write data to the media.
Byte 03
Byte 02
Physical Block Number (PBN)
Media Type
SuperLoader User's Guide
Byte 01
Media ID
Tape Address
Tape Format
Chapter 5 Troubleshooting
A501: SDLT Hard Write Error
Byte 00
5
203