Post Failure Logs; Table 39 Tape Drive Field Descriptions - Quantum SuperLoader 3 User Manual

Table 39 Tape Drive
Field Descriptions
Field
Event Log Number
Event Number or
Name
POH/PC
POST Failure
1
Logs
Description
A sequence number that indicates the order in which the event was
logged.
This field appears in every event log, but varies depending on the
event type. This field indicates the type of log.
The tracking information for how many power-on-hours (POH) the
drive has had since it was shipped from Quantum. This is how many
hours the drive has had power applied regardless of the number of
times it is turned on and off. POH is updated once every 60 minutes
the drive has had power applied to the drive with no interruptions.
Power cycles (PC) is how many times the drive has experienced a
power on cycle. Each time a drive logs a Hard Event, it will increment
this count as well.
In addition to these main fields, each type of basic information log
contains specialized fields. Refer to the following sections for information
about each log types' fields:
•

POST Failure Logs

• DLT Drive Diagnostic Results Logs
• DLT Firmware Changes
These events indicate that the SuperLoader or tape drive detected a
failure when power was applied. The POST may have failed during a
reset and retry (see figure
This event type only indicates each time the test ran and
Note:
experienced the error condition.
SuperLoader User's Guide
Appendix A Basic Information Logs
123).
Tape Drive Logs
239