Logout; Set Change Mode Settings; Using Data Cartridges - Quantum SuperLoader 3 User Manual

Logout

4
Set Change Mode
Settings 4
Using Data
Cartridges 4
9 Press to submit your password. You return to the Enter
Enter
Password submenu. If you submitted an incorrect password,
appears on the LCD and the row of asterisks reappears so that you
can re-enter the password.
When you enter a password, all password-protected functionality is
available until you log out (see Logout). If you do not use the front panel
for a period of time, the logo reappears on the LCD. When the logo
reappears, the SuperLoader has automatically logged you out. You will
have to re-enter your password again to access the menu functionality.
To logout of the SuperLoader, use the following procedure.
1 On the main menu, scroll to
2 On the Commands submenu, scroll to
appears on the LCD.
Session Complete
You can also press
Note:
as required until the logo appears.
Escape
To modify the change mode, see
If your SuperLoader is equipped with the DLT1 drive, you must use
DLTtape IV media. If your drive is the SDLT 220, SDLT 320, or SDLT 600
drive, it can read DLTtape IV media but can read and write only to SDLT
tape. If your SuperLoader is equipped with the LTO drive, it can read and
write to Ultrium format tape only.
If you try to load an incompatible tape, the fault status LED will show
solid yellow and the LCD screen shows an error message.
SuperLoader User's Guide
Chapter 4 SuperLoader Operation
Front Panel Functionality
, then press
Commands
, then press
Log Out
to log out. Continue pressing
Escape
Setting the Change Mode
Incorrect
.
Enter
.
Enter
on page 46.
77