Rack Mounting The Autoloader - Quantum SuperLoader 3 Quick Start Manual

SuperLoader™ 3 Quick Start Guide

Rack Mounting the Autoloader

Table 1 Rack Hole Types
6
This section provides the steps for attaching the autoloader directly to the stationary rails
of a rack. Refer to table 1 for information on common rack hole types.
Figure Description
Square rack holes are the most
common type of rack holes.
They can accept either cage
nuts which mount from the back
Cage nut
of the rail or clip nuts which clip
on from the side of the rack rail.
Clip nut
Through holes require clip nuts
Clip nut
to accept mounting hardware.
Threaded holes require neither
cage or clip nuts to accept
mounting hardware.
Note: The rails within the rack have a hole pattern that repeats throughout the rail.
1 Install two clip nuts, 1.75 in. (44.45 mm) apart, onto each of the four rails of the rack,
making sure that you install each pair of clip nuts at exactly the same level (see
figure 2).
Rack Mounting the Autoloader