Lagcrate -- Set Ramp Rate Of Line Input Agc; Lec -- Enable Or Disable Lec - Polycom Vortex EF2211 Programming Manual

LAGCMIN is set to -10, then the AGC for that channel can apply a minimum of -10 dB of gain to the
input signal.
This command was introduced in firmware version 2.5.0.
This command is a channel integer command. See
on this type of command. The minimum and maximum values for this command are -15 and 0,
respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description
Set AGC minimum gain on input
S01LAGCMINA-3
channel A to -3 dB.
Query the AGC minimum gain on
S01LAGCMINB?
input channel B.

8.72. LAGCRATE -- Set Ramp Rate of Line Input AGC

This command sets or queries the maximum rate at which the AGC can increase or decrease the gain
of the signals on input channels A-B. The ramp rate is expressed in dB/sec.
This command was introduced in firmware version 2.5.0.
This command is a channel integer command. See
on this type of command. The minimum and maximum values for this command are 1 and 5,
respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description
Set AGC ramp rate on input
S01LAGCRATEA3
channel A to 3 dB/sec.
Query the AGC ramp rate on input
S01LAGCRATEB?
channel B.

8.73. LEC -- Enable or Disable LEC

Section 6.3 and Section 6.2
Status Message
S01LAGCMINA-3
S01LAGCMINBx , where x is a number
between -15 and 0, depending on the
current setting of the AGC minimum gain on
input channel B.
Section 6.3 and Section 6.2
Status Message
S01LAGCRATEA3
S01LAGCRATEBx , where x is a number
between 1 and 5, depending on the current
setting of the AGC ramp rate on input channel
B.
for more information
for more information